vPower and Kanger T3 behaving weird after recharging

[dandellion]

I got my first VV mod - a vPower. Hooray!
I put Kanger's T3 on it and enjoy. After a while, batts go out and I use USB charger to get them back to life. Screw the clearomizer back and it won't work.
First I thought that inner contat got pushed in as it happens on some eGo batts (though I won't expect that on mod). No, it's not that.
I try a simple 510 atomizer I use for dripping and it works. So, I conclude it's about clearomizer. I try it with an eGo batt, but it works.

So I change the bottom part of the claro, atomizer on it was a bit dirty anyway... and it works again on vPower. Until batts are recharged and then we're back on the square two. Clearo works on eGo but not on vPower, while cheap atomizer works on any.

Any ideas what is going on here?

 

[State O' Flux]

Interesting. I'm going to offer advice... but perhaps not what you expect.

Get a T3S base and T3S coil heads... this will turn your T3 into a T3S - with replaceable coil heads. The T3S heads are half the price of what you're paying now for the entire T3 base/head assembly. Not only will this save you some cash, but the T3S coil heads work better, and it might... might eliminate your current problem.

If you have a meter, you can test continuity through the base and head... that's the only thing I can think of, is you have a intermittent continuity issue with T3 bases.

 

[dandellion]

Thanks for the tips. I will get T3S. Actually, it's in the package on the way across the ocean together with anywape Davide
I'm asking more because I can't see any logic in the bahaviour of the clearomizer. Gotta grab some meter and see how it really behaves.

 

[State O' Flux]

Hope you get it sorted out. I'll keep my subscription to this thread... if you figure it out, I'd like to hear the story.

Cheers,
C