Vv reo

[m3nace]

My vv reo just came in yay but im having problems with the door it doesnt glide up and down I have to stick my finger in the juice door and use a little effort did any of you habe this problem and if so how did you fix it

Sent from my SGH-T889 using Tapatalk

 

[Krazirob]

it'll wear out after opening it and closing it over the time......mine was rough but now it glides like butter


I only had this problem with the wrinkle paint door.....not the smooth finish one....which one is yours?

 

[m3nace]

Smooth paint one

Sent from my SGH-T889 using Tapatalk

 

[DoogieTony]

I'd try sliding the door up & down for a while, if that doesn't smooth it out you can try gently bending the door but I'd only do this as a last resort.

 

[Filthy-Beast]

After sliding several times you should be able to see slight wear marks and thus know what's binding. With this knowledge the fix will be a lot easier.

 

[m3nace]

I was gonna slide my grand door down it lol they're the same width right the vv is just taller

Sent from my SGH-T889 using Tapatalk

 

[Raynman]

I'm not sure using the other door will do much good. Either the door or the mod has a burr on it. Just use the door that came with it and run it up until it comes off a few times and repeat in the down direction. It is soft aluminum and will wear the burr off quickly.

 

[turbocad6]

hell I hate the loose sliding door, I purposely make mine tight and resistant to sliding around

 

[mogium]

Maybe the magnets ? Lol

 

[m3nace]

No it was a burr like raynman said it slides much better now

Sent from my SGH-T889 using Tapatalk