So this will be my first venture into using a Kick and I just wanted to make sure I do it right. I've been doing some research and found a couple pages on the long VMOD thread that pertained to using a Kick. It looked like there were a couple ways to do it. I saw pictures where they used copper on the sides of the battery housing where the kick would go. This seems like the easiest way to do it. Is it as simple as putting copper tape so that the kick makes contact with it? Does anything else need to be done?
I also saw where someone mentioned just connecting the spring on the Kick to the ground spring with wire. Is either method better than the other. I really appreciate any help with this as I have never done this before. These two methods seem so easy I wasn't sure if that was correct.
Thanks guys.
I also saw where someone mentioned just connecting the spring on the Kick to the ground spring with wire. Is either method better than the other. I really appreciate any help with this as I have never done this before. These two methods seem so easy I wasn't sure if that was correct.
Thanks guys.
Last edited:
