Wattage (help)

[Pisces82]

For TFV4 occ.

Tri-coil
Best flavours and vapor between 70-85watts

Quad-coil
Best flavours and vapor between 70-90watts

Sextuple-coil
Best flavours and vapor between 65-80watts

Sent from my SM-N910G using Tapatalk

Alright man.. Thanks a lot. Ure the best.[/QUOTE]
Ive seen reviews on youtube where people are going higher on the wattage, for example riptrippers, richard ng, suckmymod, twisted, some go as high as 120w. My own personal take on it is if we do go that high it mutes the flavour alot, all we get is a slightly butter taste and loads of clouds. They crank up the wattage as they are on high % vg based juices whereas here in sg, most of us, not all, are on either 60/40, 50/50 or 70/30. My own two cents.

Sent from my SM-N910G using Tapatalk[/QUOTE]
Okay I get it. When I adjust the wattage the ohm changes. So i vape. And there's so much juice in my mouth.Still don't know where my mistake is. rba single coil failed. Now occ fail too. Frustrating.

 

[Pisces82]

These are the steps i personally take on like a daily ritual when changing occ's.

Make sure you prime your occ's well. Drop the juice bit by bit into the holes till you see the cotton in the opening on the sides are saturated.

Next you assemble your tank as per normal and fill it up.

Close all airholes on the tank and the driptip.

Take around 5 long and hard puffs as hard as you can, do not fire your mod, just suck that beast like a biatch, you will see bubblex popping up, that a good sign, it means the cotton in your occ is properly soaking and saturating the juice.

Let it sit for around 5 mins.

Start off with 40w 5 puffs each with rest in between and take it up 10w by 10w till you reach your desired wattage.

Not sure if this is the right way to do it. But it works for me.

Sent from my SM-N910G using Tapatalk

Okay will try right now.

 

[Nimaz]

I found the chart below the other day. I am not quite sure how relevant or helpful it could be since many are running at higher watt than indicated. Maybe someone with better knowledge can comment on it...

 

[Pisces82]

QUOTE="NaughtyClownn, post: 16727953, member: 265413"]These are the steps i personally take on like a daily ritual when changing occ's.

Make sure you prime your occ's well. Drop the juice bit by bit into the holes till you see the cotton in the opening on the sides are saturated.

Next you assemble your tank as per normal and fill it up.

Close all airholes on the tank and the driptip.

Take around 5 long and hard puffs as hard as you can, do not fire your mod, just suck that beast like a biatch, you will see bubblex popping up, that a good sign, it means the cotton in your occ is properly soaking and saturating the juice.

Let it sit for around 5 mins.

Start off with 40w 5 puffs each with rest in between and take it up 10w by 10w till you reach your desired wattage.

Not sure if this is the right way to do it. But it works for me.

Sent from my SM-N910G using Tapatalk[/QUOTE]
Im doing it right now dude. Saw the bubbles and now it's resting. I hope this works.

 

[NaughtyClownn]

Okay will try right now.

If youre saying that there is alot of juice in your mouth, ensure that you screw the top portion of the tank properly, you can see the o-ring, it has to be sitted inside the occ, if you can still see it mean you have to turn it tighter. If it leaks into your airholes what i do is to open it wide, wrap a kitchen tissue around 3 of the airholes and blow hard into the last one available, do that a couple of times and the juices should be out properly.

Sent from my SM-N910G using Tapatalk

 

[NaughtyClownn]

Not sure is this has been mentioned. Just recommending this app to those who are unsure about the wattage levels, what is safe what is not. So far the readings on this app has been quite reliable for me, not totally but quite. Bahahaha.

Sent from my SM-N910G using Tapatalk

 

[Pisces82]

If youre saying that there is alot of juice in your mouth, ensure that you screw the top portion of the tank properly, you can see the o-ring, it has to be sitted inside the occ, if you can still see it mean you have to turn it tighter. If it leaks into your airholes what i do is to open it wide, wrap a kitchen tissue around 3 of the airholes and blow hard into the last one available, do that a couple of times and the juices should be out properly.

Sent from my SM-N910G using Tapatalk

I'm sure the tank is properly and tightly closed. Still have juice spitting into my mouth when i vape. And the vapor is pathetic! Hahahaa. Pls don't give up on me.

 

[NaughtyClownn]

I'm sure the tank is properly and tightly closed. Still have juice spitting into my mouth when i vape. And the vapor is pathetic! Hahahaa. Pls don't give up on me.

Are you still at 20 watts?

Sent from my SM-N910G using Tapatalk

 

[Pisces82]

I found the chart below the other day. I am not quite sure how relevant or helpful it could be since many are running at higher watt than indicated. Maybe someone with better knowledge can comment on it...

Thanks Nimaz. Though m

Are you still at 20 watts?

Sent from my SM-N910G using Tapatalk

 

[Pisces82]

UOTE="NaughtyClownn, post: 16728086, member: 265413"]Are you still at 20 watts?

Sent from my SM-N910G using Tapatalk[/QUOTE]
Im on 50watts already. The tank is getting warm.

 

[NaughtyClownn]

Still not much vapor at 50w? Tank getting warm is normal. Its a known factor for tfv4.

Sent from my SM-N910G using Tapatalk

 

[Pisces82]

E="NaughtyClownn, post: 16728133, member: 265413"]Still not much vapor at 50w? Tank getting warm is normal. Its a known factor for tfv4.

Sent from my SM-N910G using Tapatalk[/QUOTE]
It's getting better. More vapor now. Bout the popping sound nvr stop each time I take a puff.

 

[Pisces82]

Still not much vapor at 50w? Tank getting warm is normal. Its a known factor for tfv4.

Sent from my SM-N910G using Tapatalk

Is there anything I shld know about the temperature control thingy?

 

[NaughtyClownn]

Is there anything I shld know about the temperature control thingy?

For TC you gotta use Nichrome coils. The triple occ is made out of Kanthal coils, it is not meant for TC, although i tried it in TC and it still works, haha! Smok has occ made specially for TC. What mod are you using again bro?

Sent from my SM-N910G using Tapatalk

 

[taps41]

Not sure is this has been mentioned. Just recommending this app to those who are unsure about the wattage levels, what is safe what is not. So far the readings on this app has been quite reliable for me, not totally but quite. Bahahaha.

Sent from my SM-N910G using Tapatalk

Best app for vaping.

Sent from my SM-N910G using Tapatalk

 

[taps41]

For TC you gotta use Nichrome coils. The triple occ is made out of Kanthal coils, it is not meant for TC, although i tried it in TC and it still works, haha! Smok has occ made specially for TC. What mod are you using again bro?

Sent from my SM-N910G using Tapatalk

TC is nickel not Nichrome bro. Nichrome is jus a softer n lower resistance wire compared to kanthal, but only nickel, titanium and stainless steel r for TC.

Sent from my SM-N910G using Tapatalk

 

[NaughtyClownn]

TC is nickel not Nichrome bro. Nichrome is jus a softer n lower resistance wire compared to kanthal, but only nickel, titanium and stainless steel r for TC.

Sent from my SM-N910G using Tapatalk

My bad. Was typing too fast till i didnt realised i typed Nichrome. Yes as mentioned it is Nickel. Lol.

Sent from my SM-N910G using Tapatalk

 

[errolng]

I found the chart below the other day. I am not quite sure how relevant or helpful it could be since many are running at higher watt than indicated. Maybe someone with better knowledge can comment on it...

this chart hasn't been relevant in a really long time

 

[Nimaz]

this chart hasn't been relevant in a really long time

I was afraid so... Do you know any recent resources on that matter? Thanks

 

[errolng]

I was afraid so... Do you know any recent resources on that matter? Thanks

dont bother with charts and just go by feel