ive got a 510 vaporizer i just started... and i seems that im not getting enough vapor from it.. even tho i add liquid to my cartridge... what should i do? any suggestions?
what can i do to fix my atomizer?....
- Thread starter element4_20
- Start date
- th_trl_thread_readers 0
- Status
Most attys come with a primer fluid in it when shipped. You most likely need to get that out of the atty first. Take the cart off, and blow through the atty into a paper towel until nothing else comes out. After that it my take a few hours to a day to completely break the atty in.
Last edited:
yes, blow out atomizer by putting the threaded end in your mouth, and a paper towel over the open end. Then once you get most of the liquid out, prime it with a couple of drops of liquid if you have it or if you don't, install your cart and let it sit for a few minutes to let the liquid in the cart wick down, then try again. Remember to take slow long draws, not quick hard pulls when you go to inhale. I hope this helps.
Welcome. Also be sure to line up the cart with the bridge which can help with the draw; and a higher concentration of VG can increase the vapor. Many times new systems come with an e-liq that has a pretty high PG level.
Good luck - draw slow and drink water.
Good luck - draw slow and drink water.
As an experiment, blow out the atty and try dripping 3 drops directly into the atty, right on the bridge. Is it better?
If yes, cart/wicking issue. If no, atty gunked/fried issue.
If yes, cart/wicking issue. If no, atty gunked/fried issue.
- Status
Similar threads
