what does low load mean?

[TimmyL]

The display says low load, the tank is full, and a charged battery put in. Still having trouble....

 

[JeremyR]

Your coil is too low of ohms for the device. Or there is a short.

 

[TimmyL]

Now the unit won't even stay on?

 

[Susan~S]

Have you tried putting another tank on it?

 

[TimmyL]

What does that do differently than putting on a different coil?

 

[JeremyR]

More information needed

 

[Susan~S]

What type of tank are you using? Is it a RTA (rebuildable coil) or are you using a tank that you buy stock coils? As Jeremy posted, we need more information.

 

[TimmyL]

It is stock coil, and the tank is a KangerTech Protank II. Maybe the batteries, they are new and freshly charged, but ?

 

[eratikmind]

The display says low load, the tank is full, and a charged battery put in. Still having trouble....

What is the resistance of your atty?

 

[TimmyL]

Figured it out, it has to be the batteries. Thank you for the answers, I am so new to this!

 

[iamthevoice]

Could just be that your atomizer is not making contact with the battery?

 

[realsis]

Usually low load means the ohm load of the coil is too low of resistance for your unit. Or it can say low res. It can also mean it is a short in the coil. Never heard of it relating to the battery but I suppose different devices can have different detection messages. In the 10 or so mods I've had its usually coil realated. Hope this helps.

 

[JeremyR]

It's not the battery. Your getting a short don't tighten the atty onto the battery so tight . Or your getting a short on the atty side. What mod?

 

[rodeo302]

Check to see if your coil is tight in the base sometimes they will loosen up.