What ohm range ?

[FenrisKomplex]

I was just wondering since I have one Ego 1000mAh passthru and a Kgo set, what ohm range of cartos should I stick to since I want to try the fluxomizers but all are above 2.0ohm. So I just wanted to check what range would be the best and safest to use.

 

[Murdock Ruml]

I prefer the 2.5-2.6 range. They work good on egos. The 2.8-3.0 ones are good on egos too, but preform better at higher volts.

 

[Stef64]

I use 2.4-2.6 and 2.6-2.8 on a Riva. The ohm ranges on the Clearomizers are not comparable to other cartos. The clearos are top coil and will produce more TH and vapor that a fillered carto of the same resistance. The 2.4 ohm clearos hit harder than the 2.0 Boge cartos or LR attys.

 

[dormouse]

You can go down to 2 ohm at the hottest end, up to 3 at the cooler end. Some will go lower but some think it's only safe to go lower on mods (ecig with industrial protected AA-like and other size batteries that come out the way a flashlight's batteries come out). I also like around 2.5 ohms on 3.7v but Ego is 3.4v so you may prefer 2.2 or 2 ohm. Depends on what you want. Heat enhances the hit of nicotine, less heat may let the flavor come through better.

 

[Freckle]

Some do not recommend it but I have used the 1.5ohm dual coils on my egos as low of a mah rating as 650. I wouldn't dare use them on anything lower though.

 

[revolver]

I say that 1,5 ohms may be not wise; and you may wanna stay on the safer side of the spectrum...

OTOH, though, I have used such LRs on my eGos for years and never had any issues. Nor any other vaper that I know of. And, the extra wattage (power) will certainly suit many. Try this at least to figure which is your sweet spot; as long as your battery is fine nothing will happen. Maybe don't over do it... Until you are sure it's fine; which you will eventually, most likely...

=)