what size drill is used for the better airflow in subtank mini??

[erin#vapoholic]

what size drill bit is used to drill the 2 holes in the subtank mini rba part? im getting dry hits and i see where most people drill 2 holes in it.. so what size is most common??

 

[xwarp]

I don't remember if this fella mentions the size.

ETA, he does mention that it's a 5/64 that he drilled, but he opened up the grooves on the bottom.

 

[erin#vapoholic]

thank you so much !

 

[hambone0424]

I used a 5/64 n never get a dry hit my also did it n then took a 1/16 drill to the bottom premade holes from kanger and he loves it but the two i put in just about center i believe i went just a little lower and i now love the rda probably will never use a stock coil again

 

[jseah]

I just used the cutoff wheel on a Dremel and cut out a slot. Took three cutoff wheels and stacked them. That formed the width of the slot and then cut it halfway up from the bottom. I had also used the Dremel to widen the juice channel in the base.