What tanks and cartos are you using on your Smok Natural

Status
Not open for further replies.

Peruviann

Senior Member
ECF Veteran
Verified Member
Feb 9, 2013
167
84
So i just recieved my smoktech natural. I'm using a carto tank with a 2.1 ohm carto.

what ohm carto would you guys recommend ? also noticed i cant make my tank flush cause of no air.

thanks for your help

28r0hts.jpg
 

Peruviann

Senior Member
ECF Veteran
Verified Member
Feb 9, 2013
167
84
That's a nice setup, try liquinator glass tank from vapebar.com , unfortunatly they are sold out right now, but its worth the wait, how's the natural? Any problems? I'm planning to buy this same exact device,

It's not to bad only paid 51 shipped. the vapor isn't to bad, I'm used to my eVic at 4.6-4.8v. One thing that bothers me is that i cant sit my tank flush because of the airflow issue. Besides that its a great mod.
 

Jimmyhat

Super Member
ECF Veteran
Verified Member
Oct 25, 2012
313
273
West Chester, Pa
if you were running your evic at 4.6-4.8v with a 2.1ohm carto you were at around 10-11watts. This would mean that to achieve similar wattage on the mechanical you would need to be around 1.3 ohms, here is a calulator to figure out what wattage your at http://www.ohmslawcalculator.com/ohms_law_calculator.php
just plug in your ohms (resistance) and voltage press calculate and the wattage and amp will appear. for the mechanical put 3.7 watts.. the battery fully charged is around 4.2 but when it's dead its at around 3.4 to be safe so 3.7 is a good middle ground. Also you will get voltage drop at the coil so say the battery is at 4.2 well the actual will be much lower maybe 3.5-4 who knows unless you check it with a multimeter. The real advantage however to mechanicals is to get an RBA that way you can run any ohm you want and don't have to worry about the circuitry in the vv/vw mods getting in the way.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread