Do ya think... if I added more VG, less PG to the mix for more vapor...it might help? And IF it is heat, TH, that he is missing....That would mean more PG...Correct? I use a 50/50 mix right now with a PG Niquid and PG base flavors.
What the HECK?? Vision Spinners and Kanger T3's
- Thread starter J&V Far
- Start date
- th_trl_thread_readers 0
-
- Tags
- evic evod myvaporstore
- Status
Nope, more VG=less flavor/more vapor
Th/heat - more wattage or higher nic
If he is missing TH increase the nic a bit
If he is missing Flavor boost the Flavor percent a bit
If he is missing the warm vape - more heat(power) is needed - caution as burning can occur.
ETA- I use the T3 mini's a lot
Shorter than the T3 so warmer vape
50/50 mix, 12mg, Delivers decent flavor - Good Vapor and is comfortably warm
T3 is slightly cooler but about the same vape quality when working correctly.
I also use these on an eVic at about 7 watts
Th/heat - more wattage or higher nic
If he is missing TH increase the nic a bit
If he is missing Flavor boost the Flavor percent a bit
If he is missing the warm vape - more heat(power) is needed - caution as burning can occur.
ETA- I use the T3 mini's a lot
Shorter than the T3 so warmer vape
50/50 mix, 12mg, Delivers decent flavor - Good Vapor and is comfortably warm
T3 is slightly cooler but about the same vape quality when working correctly.
I also use these on an eVic at about 7 watts
Last edited:
his Nic level is @16 with 10% flavor. I see clouds of Vapor when he x-hales so vapor is good. I don't know. I will keep trying.
Nice vid, also if you flip over the gasket on top of the atty it helps not only leaks but flavor. (at least it made a noticeable difference for me)
I use varying mixed with my T3s, anywhere from 80/20 to 20/80 And all have good TH. he may just need to adjust his inhale technique. The draw I use is very loose, I don't even make a complete seal with my lips on the drip tip and just very lightly draw the air in, you have to take a longer draw this way but I get a great amount of vapor and TH. Also, cotton wicks instead of the standard silica will help with flavor IMO though some don't like the flavor from cotton.
Yes it is and thank you for sharing it
. I think what is now happening is the vapor is too cool. I am probably going to end up getting him a couple of T3 Mini's and a few Top Wicks CE4's and such. I have been keeping an eye on his tanks....they are over 3/4th full each morning. I will NOT be filling them up to full from now on. All the MIX sitting in there over-night. Having to kinda swirl/stir the mix each morning. He is getting smaller tanks!!! LOL He can still use the regular T3's for any fruit flavors he likes. (Just ordered some for myself.) Just have to wait and see what happens. Either way...it will have to wait until next month...no more monies
.
Yes it is and thank you for sharing it
Bottom coil delivery devices give a cooler vape. I used the CE4's and switched 7 months ago to the Vision brand Mini Vivi Novas cuz they were far superior build quality. They are top coil which gives a warmer vape and comes with 3 heads- 1.8, 2.4 and 2.8 ohms. He'll prolly enjoy the 1.8 ohms as it gives a warm vape. If buying the Vivi Nova make absolutely sure you buy the Vision brand- knockoffs are problematic. My Vivi Nova heads (wick+ coil) are lasting about 10 weeks BUT I wash the heads every few days. They are inexpensive ($2.00) and easy (10 sec) to replace. Holds 2.0 ml.
she said smaller tanks -
That would leave Stardust, mini T3's, Evods, or Ce3 styles
Personally from all the good comments from members, I'd try the Evod.
Not to pricey and simple to rebuild if desired. Also recommend running around 2.0ohm coils for decent heat production without over driving batteries.
That would leave Stardust, mini T3's, Evods, or Ce3 styles
Personally from all the good comments from members, I'd try the Evod.
Not to pricey and simple to rebuild if desired. Also recommend running around 2.0ohm coils for decent heat production without over driving batteries.
The Vision Mini Vivi Nova 2.0 ml on a Spinner for a size comparison
There's a reason the Vivi was one of the first items out of stock with many vendors.
There's a reason the Vivi was one of the first items out of stock with many vendors.
Higher initial cost
Higher freight cost
Less preference over full size
Lower inventory.
I like Vision tanks, but there is more than one reason for out of stock
Original tank+ 3 heads= $10.00- my weekly cost= 15 cents.
Cost of a letter.Mini Vivi Nova 2.0 ml were sold out but lottsa 3.5 ml available.
Spoke to an acquaintance who's one of the larger vendors and he told me the Vivi Mini is his most popular product with next to no complaints.
of wick that dislo
My first kanger had a loose wick on it. I needed to take it apart and reinsert the piece dislogled. You can try adding a small piece of cotton
Bought the bullet and got a few (5) ViVi Nova metal tanks....One leakin a bit. Another leakin some, but other than that..is all good.
- Status
Similar threads
- Locked