What's a good mech mod to go with SLR coils?

[guppy]

I'm trying to find a good mechanical mod that would be able to run SLR coils. I had a china mod and it couldn't take a .3 ohm dual coil and the button spring popped. Another mech mod I have, the negative coil just collapses... So what's a decent priced or an easy obtainable mech mod that would be able to handle SLR coils?

 

[aPandaz]

Where in SoCal are you? There are quite a few shops here that are picking up mods from the Philippines. Mortar v5, Pipebomb v3, Nzonic, Sentinel...some are waiting on the Avenger v3 to be shipped...Atmizoo Dingo is in stock at Vape Revolution. Call around.

 

[guppy]

Where in SoCal are you? There are quite a few shops here that are picking up mods from the Philippines. Mortar v5, Pipebomb v3, Nzonic, Sentinel...some are waiting on the Avenger v3 to be shipped...Atmizoo Dingo is in stock at Vape Revolution. Call around.

all of the ones listed can handle them SLR coils? I'm in Alhambra about 20 minutes west of you

 

[aPandaz]

One of the guys in a local shop was running a 0.3ohm dual coil setup in a Nimbus on top of a Mortar v5. Massive clouds.

 

[guppy]

One of the guys in a local shop was running a 0.3ohm dual coil setup in a Nimbus on top of a Mortar v5. Massive clouds.

I had massive clouds up until the spring popped then I had a massive problem...

 

[aPandaz]

I'm using a Mortar v5, but I'm afraid to go lower than 0.8 ohms. I think that's right at the drain limit of my batteries and I don't want to damage them.

 

[guppy]

I'm running .5-.6 on my AC9 and it works great! but with lower ohms, men's it needs more air or else it'll be a hot @as vape...

 

[muzichead]

I'm trying to find a good mechanical mod that would be able to run SLR coils. I had a china mod and it couldn't take a .3 ohm dual coil and the button spring popped. Another mech mod I have, the negative coil just collapses... So what's a decent priced or an easy obtainable mech mod that would be able to handle SLR coils?

First off, I need to stop laughing so hard so I can type this.... Why would you need to vape a .3Ω coil, much less in paralell??? You are asking to be the next poster boy for dangerous vapors... Your lucky the battery didn't explode and take your face off!!! A .3Ω coil on a freshly charged battery would be 58.8w and 14amps!!! So if I am reading this correctly, you are pushing 28amps!!!! Now i'm ...... off and disgraced as a vapor.... There is only 1 battery on the market that claims it can handle 20amps, and the jury is still out on that one, and you are trying to push even that!!! The first thought that comes to mind is are you that crazy or that stupid??? A .5Ω coil is about the lowest resistance coil that should be safely, (and I use that term very loosely), vaped... We have been lucky that there hasn't been an incident since early last year and with the FDA heat on us right now, we don't need to give them an excuse to get what they want to achieve... This is why all the battery warnings are out there from mfg's and vendors and some people should actually read them....

There is "NO APV" on the market that will handle the stupidity you are trying to achieve!!!!!!

 

[Rule62]

Apparently, the rise in popularity of RBAs has given rise to a new, sub culture of vapers, the "vapor chasers". The vapor chasers obviously have no interest in achieving the best possible flavor from their juice; but instead, are interested in nothing more than replicating a fog machine at a rock concert. I don't get it. If I wanted to do that, I'd go find a road construction crew, and stick my face over the asphalt cart.
If you're collapsing springs, and heating up switches to the point that you can't even touch the button, you're obviously doing something that you probably shouldn't. My only hope is that if you blow your teeth out, or burn your fingers off, nobody hears about it. The vaping community is under enough fire as it is.

 

[muzichead]

After I submitted my reply I happened to glance and see what his join date and post count was and then it hit me all at once!!! The entire post made sense to me...NOT!!! I can't help but think of the famous Forrest Gump phrase right now..."my momma said stupid is as stupid does"...

 

[guppy]

First off, I need to stop laughing so hard so I can type this.... Why would you need to vape a .3Ω coil, much less in paralell??? You are asking to be the next poster boy for dangerous vapors... Your lucky the battery didn't explode and take your face off!!! A .3Ω coil on a freshly charged battery would be 58.8w and 14amps!!! So if I am reading this correctly, you are pushing 28amps!!!! Now i'm ...... off and disgraced as a vapor.... There is only 1 battery on the market that claims it can handle 20amps, and the jury is still out on that one, and you are trying to push even that!!! The first thought that comes to mind is are you that crazy or that stupid??? A .5Ω coil is about the lowest resistance coil that should be safely, (and I use that term very loosely), vaped... We have been lucky that there hasn't been an incident since early last year and with the FDA heat on us right now, we don't need to give them an excuse to get what they want to achieve... This is why all the battery warnings are out there from mfg's and vendors and some people should actually read them....

There is "NO APV" on the market that will handle the stupidity you are trying to achieve!!!!!!

don't act stupid and just either answer the question or quit nagging. I know the risks of this. I'm sure you continue eating salt even though it increases your chances of heart disease and also sugar which will "possibly" give you diabetes... are you gonna cut those ingredients out of your diet because it can "possibly kill or potentially harm you?

 

[guppy]

join date doesn't mean e cig start date... just like your quote says... stupid is as stupid does... when you assume it makes an ... of you and me....

 

[guppy]

Apparently, the rise in popularity of RBAs has given rise to a new, sub culture of vapers, the "vapor chasers". The vapor chasers obviously have no interest in achieving the best possible flavor from their juice; but instead, are interested in nothing more than replicating a fog machine at a rock concert. I don't get it. If I wanted to do that, I'd go find a road construction crew, and stick my face over the asphalt cart.
If you're collapsing springs, and heating up switches to the point that you can't even touch the button, you're obviously doing something that you probably shouldn't. My only hope is that if you blow your teeth out, or burn your fingers off, nobody hears about it. The vaping community is under enough fire as it is.

if you wanted full flavor go eat or drink the real product instead of vaping... that'll give you the full flavor you're looking for... you are right about the chasing vapor part but recommending asphalt is just plain stupid... even as a metaphor...

 

[fanatic205]

I'm trying to find a good mechanical mod that would be able to run SLR coils. I had a china mod and it couldn't take a .3 ohm dual coil and the button spring popped. Another mech mod I have, the negative coil just collapses... So what's a decent priced or an easy obtainable mech mod that would able to handle SLR coils?

First off, I need to stop laughing so hard so I can type this.... Why would you need to vape a .3Ω coil, much less in paralell??? You are asking to be the next poster boy for dangerous vapors... Your lucky the battery didn't explode and take your face off!!! A .3Ω coil on a freshly charged battery would be 58.8w and 14amps!!! So if I am reading this correctly, you are pushing 28amps!!!! Now i'm ...... off and disgraced as a vapor.... There is only 1 battery on the market that claims it can handle 20amps, and the jury is still out on that one, and you are trying to push even that!!! The first thought that comes to mind is are you that crazy or that stupid??? A .5Ω coil is about the lowest resistance coil that should be safely, (and I use that term very loosely), vaped... We have been lucky that there hasn't been an incident since early last year and with the FDA heat on us right now, we don't need to give them an excuse to get what they want to achieve... This is why all the battery warnings are out there from mfg's and vendors and some people should actually read them....

There is "NO APV" on the market that will handle the stupidity you are trying to achieve!!!!!!

I have run dual coils @.3 ohms on a I hybrid and have never had a problem. I use 20amp samsung batteries so thereare more than one brand of batteries that can handle 20amps. If you test the voltage output while firing the PV even off the charger your not getting true 4.2 volts. If you use safe chemistry batts the worst that will happen is the battery vents some gas if all goes bad.
I have been vaping at .6ohm and under for months and my two co workers vape the.same setup i use and our PV's handle it fine. I dont suggest vaping super low ohms unless you know the.risk and are comfortable doing soso

I vaped on dual 1ohm coils with stacked 16340 batterys at about 45 watts when testing while firing the pv i was getting 7.1 volts.

PS .3 ohm coil at 4.2 volts.is only 14 amp draw in reality you will only pull around 12 amps not 28. I wouldnt laugh at someone when your information is no where near correctcorrect

 

[medicmckay]

Lol...
Salt doesnt cause hypertension....and sugar doesnt cause diabetes.....
Dual coils on an ihybrid or a synthesis....can't say mine has a second wick hole. And at 0.3 ohms or 0.6 with stacked batts something tells me there is absolutely no flavor left and the vape taste like burnt ..... let me go find leiutenant dan i think he's got a few things to mention

 

[medicmckay]

Lol...
Salt doesnt cause hypertension....and sugar doesnt cause diabetes.....
Dual coils on an ihybrid or a synthesis....can't say mine has a second wick hole. And at 0.3 ohms or 0.6 with stacked batts something tells me there is absolutely no flavor left and the vape taste like burnt ..... let me go find leiutenant dan i think he's got a few things to mention

 

[fanatic205]

Lol...
Salt doesnt cause hypertension....and sugar doesnt cause diabetes.....
Dual coils on an ihybrid or a synthesis....can't say mine has a second wick hole. And at 0.3 ohms or 0.6 with stacked batts something tells me there is absolutely no flavor left and the vape taste like burnt ..... let me go find leiutenant dan i think he's got a few things to mention

I guess you never had heard of a drill, and if you have never vaped SLR I wouldnt comment to the OP about it. Alot of people vape .6 ohm coils with great flavor adding a second .6 ohm coil only gives more vapor and no burnt taste.

Also all the battery failures i have seen are user error or using a clearly damaged battery. I had a friend burn his neather regions with a couple batterys and hemostats in a fannie pack. Not a good idea to put batteries in side a fannie pack with a long steel stick inside it, again that falls under user error.

Let me correct myself when i was stacking batteries it was dual 2ohm coils for 1ohm total and 45 watts tons of vapor and flavor

 

[muzichead]

don't act stupid and just either answer the question or quit nagging. I know the risks of this. I'm sure you continue eating salt even though it increases your chances of heart disease and also sugar which will "possibly" give you diabetes... are you gonna cut those ingredients out of your diet because it can "possibly kill or potentially harm you?

I did..... There is "NO APV" on the market that will handle the stupidity you are trying to achieve!!!!!!

 

[CloudZ]

An over salted french fry will not explode into a violent fireball that knocks your teeth out and melts your face off.


0_0 *** Sent from my Droid Incredible 4G LTE *** 0_0

 

[fanatic205]

don't act stupid and just either answer the question or quit nagging. I know the risks of this. I'm sure you continue eating salt even though it increases your chances of heart disease and also sugar which will "possibly" give you diabetes... are you gonna cut those ingredients out of your diet because it can "possibly kill or potentially harm you?

I did..... There is "NO APV" on the market that will handle the stupidity you are trying to achieve!!!!!!

Clearly you havent vaped SLR I am at this moment vaping on a .3 ohm aga-t on a precise 18650 havent rewraped the aga in about a month and the precise is handling the load pretty well.

The stupidity is talking about something you clearly have no clue about....