Whats my SW200 doing???

[Jack H]

Just started getting "bad behavior" from my SW 200 v1.5. I use Lemo II n200 coil TC mode.

After I stop using for a few minutes, the SN will not fire. The readings are normal, but press the fire button and it shows 0.0W right off the bat. No power going to the coil.

If I unscrew the LEMO and fire so it says no atomizer, then screw it back down, and answer yes to new atomizer, it works fine again.

I have tried this on 3 different rta's and it does the same thing. It is like the SW loses it's TC settings for just sitting.

Anyone else see this issue?

 

[Matthewlol]

Just started getting "bad behavior" from my SW 200 v1.5. I use Lemo II n200 coil TC mode.

After I stop using for a few minutes, the SN will not fire. The readings are normal, but press the fire button and it shows 0.0W right off the bat. No power going to the coil.

If I unscrew the LEMO and fire so it says no atomizer, then screw it back down, and answer yes to new atomizer, it works fine again.

I have tried this on 3 different rta's and it does the same thing. It is like the SW loses it's TC settings for just sitting.

Anyone else see this issue?

I had a similar problem recently and I was told to throw my temp all the way up over to Celsius then back down to the temp I was at to begin with. After the first time its been working since.