Where to find ceramic wicks for aga t+
- Thread starter Bunyan
- Start date
- th_trl_thread_readers 0
- Status
The wicks currently for sale will not fit the standard wick hole in an AGA T+. They do not make the 3/32" size any more. You can fit the new wicks if you are prepared to drill out the wick hole. AC9s, DIDs, Temons have much larger holes that accommodate ceramic wick sizes very well without any modification.
If you are talking about the solid porous ceramic wicks then you are at a loss. Either you can make your own (lookup Fishwick threads made from the Top Fin bubbler air filter) to 3/32 or you will have to drill your AGA T+ as Steve W stated.
Most ceramic wicks are 1/8 or I have seen the new 7/64 size.
Most ceramic wicks are 1/8 or I have seen the new 7/64 size.
I had gotten a couple ceramic wicks for my AGA-T from SandsMODS. They sell the AGA and I had inquired via email. They did not have on site but did get a couple.
Ended up not being as good as hoped. so now using a hybrid SS U wick which is working out not bad. Had to punch out the second ground hole of course.
Good luck.
Ended up not being as good as hoped. so now using a hybrid SS U wick which is working out not bad. Had to punch out the second ground hole of course.
Good luck.
If you own a Dremel, one bubble stone will make more than enough wicks than you will need for the price of 2 pre made wicks.
What Mr. Bungle said. I bought some of the fc 2000 wicks when they first came out and where available. Since then I have been using nothing but the airstone wicks. I can make one whenever I want or need (though if you are careful you don't need them often) and I don't have to wait for them to be in stock. They are a fraction of the cost not that it is a huge deal but I get the same performance out of these as the fc2000s.
- Status
Similar threads
