RDA Which dripper for an MVP

Status
Not open for further replies.

darknecrotic

Senior Member
ECF Veteran
Verified Member
  • Oct 6, 2014
    96
    101
    Columbia, SC
    www.caraudioinc.com
    I apologize if this isn't the right section.

    First off, I know drippers aren't ideal for a device that only goes up to 11 watts and has such a low amp limit. But I won't be sub-ohming. The lowest resistance I'll probably be goin to is 1.2 ohms but probably more like 1.5-2.0 ohms

    I would like it to be 22mm or lower in diameter. Smallish chamber and average airflow. (Figured this would be better for the lower wattage.)

    I don't want to spend more than $50 and I don't care if it's a clone. I'm just looking for some suggestions, because there are tons of drippers out there and I don't have any experience with them.

    I appreciate any input! :)
     

    LoveVanilla

    Ultra Member
    ECF Veteran
    Nov 23, 2013
    1,926
    3,736
    Texas
    The two I use on a regular basis -- and good success --on the MVP are mini-A7s and Magma. I try to build around 1.8 ohms and then typically vape around 8 watts. The mini-A7 because they yield good vape and excellent flavor while allowing frequent changing flavors (e.g. after 5-7 puffs). The Magma yields decent vape and good flavor and has a large juice reservoir. Both are inexpensive FT clones. Enjoy.
     
    I used an Atomic clone on an MPV for quite a while as an "at work vape". Its a smaller diameter RDA than the usual 22mm and it has adjustable air flow as well as the smaller chamber you're looking for. Dual coil 32ga came out to 1.3 and actually produced nice flavor and vapor. But of course you can coil it to your preferences. Not to mention they really do look pretty good together.
     
    Status
    Not open for further replies.

    Users who are viewing this thread