Why do the ohm's keep changing

[Gibby92]

I tested my coil with a multimeter and it was 1.3 ohm's but when i put it on my itaste svd it keeps changing sometimes it says 1.3 then I check it again and it says 2.5 or anything in between.

 

[dripdaze]

Verify all of your connections are solid.

 

[dice57]

Yeah, sounds like you need to tighten the screws on the coil leads. Also make sure the coil isn't touching down somewhere and causing a short.

 

[Gibby92]

I pushed the coil's in tighter and it is saying 1.3 again one off the wraps must have moved slightly (i have been using it for a few days) thanks for the fast replys.

 

[edyle]

I'm thinking more likely the coil it 2.5 but the negative side of the coil wraps sometimes touches the side and the ohms drops when that happens.

When my coil is reading off sometime I just slap the tank, and try again;

 

[Gibby92]

I'm thinking more likely the coil it 2.5 but the negative side of the coil wraps sometimes touches the side and the ohms drops when that happens.

When my coil is reading off sometime I just slap the tank, and try again;

The coil is 1.3 i just used 2.5 as an example. Its reading 1.3 now i think it was a mixture of needing to tighten the posts and making the wraps tight again.

 

[PoeDung]

If you have a 510 connection that screws in and out, try unscrewing it so it can make connection, you also try cleaning the inside of the connection out with a q-tip or napkin.