RDA Why does my rda keep reading weirdly?

[jacob bonilla]

I put it on the ohm reader it read 0.64 then I run it in my mod which is an evic vt 60w it reads 0.83 sometimes 0.70ish depending how much juice is in it. and VERY OFTEN it will read 0.00 ohms.

mod - evic vt 60 watt
rda - Mutation xs ( aka Mutation x v4 mini )

this is my first rda/time building it vapes fine but after every so often it will just read 0.00 is it because I cut off my wire when screwing it in or what is going on?

 

[BackDoc]

check to see if your coil is loose, tighten it........also make sure its not touching the post

 

[WindyCityJoe]

What BackDoc said plus check your 510 connection, make sure they're clean and making good contact.

 

[jacob bonilla]

I think it was my screw/coil was loose. tightened it againd for the 2nd time and it seems fine now . earlier I checked it and did that and it read 0.00 which was weird so I loosened it up

 

[MattyTny]

I think it was my screw/coil was loose. tightened it againd for the 2nd time and it seems fine now . earlier I checked it and did that and it read 0.00 which was weird so I loosened it up

If anything you should only have to tighten the posts capturing the wire, making it loose will cause more inconsistent readings. You should check to make sure your coil and clipped wire leads are not touching anything.

You should also check that all your connections are clean and snug. Check the battery contacts, the device's battery contacts, the device's 510 pin and threading, the atomizer 510 pin and threading.

 

[jacob bonilla]

i made a new wire last night to practice building the coil read spot on 0.53 i tightened the posts. i did have to clean the atty an mod though it was leaking but i think it was simply due to posts not being screwed down tight enough.