Why does my tank work on some devices and not others?
- Thread starter ChelsB
- Start date
- th_trl_thread_readers 0
- Status
One of 2 things it could be.
No connection is being made therefore follow the previous poster's advice and see if you can lower the pin on the atty. Being the mod has a spring loaded 510 pin, I don't advise messing with it.
The 2nd thing may be that the coils don't have the newer type of wiring to be run on more advanced mods. But since it runs on the Hana that may not be the case.
eta--oops---make it 3 things...lol
maybe the coil resistance is too high for this mod????
Had the exact same problem with my other half's pro tank. She was using it on an ego one battery The bloody thing had a constant intermittent fault (if there can be such a thing). The dam thing was working then not working then working the not working and so on. I couldn't work out whether it was the connection on the coil the connection to the base of the tank or the connection on the AFC base. I spent so long tinkering with it only to find it would go again. So I scrapped it and got her a Bayou carto tank with a diver carto
Sent from my iPhone using Tapatalk
My everytime solution: FastTech - Gadgets and Electronics
Also fine for avoiding problems with "pseudo-hybrid" mech mods.
Also fine for avoiding problems with "pseudo-hybrid" mech mods.
It's especially problematic with my aero tank. It used to work, now it doesn't (yes, I've changed coils)
Just take a toothpick and press the center of the "battery" down...give the spring a kick...a little.
Ohmyenglish...don't find the right words, but I hope, You understand! Make it "relax"!
Ohmyenglish...don't find the right words, but I hope, You understand! Make it "relax"!
Just take a toothpick and press the center of the "battery" down...give the spring a kick...a little.
Ohmyenglish...don't find the right words, but I hope, You understand! Make it "relax"!
I completely understand. Thank you![emoji4]
No, I meant I understood what he was saying. Still isn't working...
I have run into this and found the slightest lit bit of e-Liquid on the contact of the 510. A quick wipe on a paper towel or napkin solved the issue. Just a thought because it is so simple it can be easily overlooked!
Good Luck!
Good Luck!
The 510 on the M80 is, iirc, notoriously deep... if it is truly important that your PTs run on the M80, you can attempt to gently lift the center pin. If it will not stay elevated, sometimes a DT o-ring can be slipped uner it to raise it. If it is not necessary, and there are other tanks that work on the mod and other mods for the PTs, do not muck about...
Sent from my SAMSUNG-SM-N910A using Tapatalk
Sent from my SAMSUNG-SM-N910A using Tapatalk
- Status
