will a 2.8 ohm cartomizer work good on my Ego-T 3.2 volts battery?

[Formosa]

Hi will a 2.8 ohm cartomizer work good on my Ego-T 3.2 volts battery? I usually use the Boge 2.0 LR on this battery but would like to try something else. Thanks.

 

[Racehorse]

Was the 2.0 too hot or too cool for you?

I think it would be better on an ego twist, where you could dial in a higher wattage. I don't like super low resistance vaping, but 2.8 is not going to give you vapor as you see by the chart. 2.4 is the highest ohm you would want

Take a look here:

 

[Buggs5347]

I use Boge SR cartomizers on my Ego C battery. I believe the battery is really the same as an Ego T battery.

 

[Unforeseen]

Moved to Assorted PV Topics - Cartomizers

 

[steved5600]

The combo you mentioned would be too low a wattage for a good vapor. I find that the chart above is good. Your setting at 3.657142857142857 watts which is off the bottom end of the charts good vape area. Goal is between 4-8 watts.here is an XL spread sheet that will do the calculating for you. Just don't change the numbers in the red areas.View attachment 138895

 

[Formosa]

Thanks guys, The boges are disappointing lately due to their quality. Can some one recommend a good substitute for a Boge 2.0 LR cartomizer? I prefer the 40mm long in stainless silver just like the Boge 2.0 LR. Thx again.

 

[ninjuh]

Thanks guys, The boges are disappointing lately due to their quality. Can some one recommend a good substitute for a Boge 2.0 LR cartomizer? I prefer the 40mm long in stainless silver just like the Boge 2.0 LR. Thx again.

Any of these work awesome www.ikenvape.com