Will eGo Twist work with ST low-ohm DCTs?

[dBm0]

Courious if anyone has had success with the eGo Twist using SmokTeck 1.5ohm DCT? Is there a high-amp safety cut-off concern above 3.7 volts or a short circuit protection issue with these? TIA.

 

[Kent C]

I used the EMCDD (1.6Ω) on the TWIST. All eGo-c batts, the regular, 'upgrade' and the TWIST have added short and charge proetection that the eG0-t and earlier eGo's didn't have.

The EMCC vaped well on the TWIST, until... I turned it to 4.8V and the wattage (14.4W) was too much for it. Didn't harm the batt but the carto was dead. I've since vaped at around 4.2V (@11W) with no problem.