Will It work????

[spencerjames]

Okay, so I've upgraded by ordering my first mod, I got a hades 26650 mech mod, with a tobh atty v2, I have never built my own coils, and I was quite overwhelmed doing my reading on ohms, watts, voltage, and all that. I ordered 10 pre-made, 26 gauge kanthal wire coil, with 1.2 resistance, off of eBay. I ran it through my ohm calculator, and it seemed alright, yet again I'm not exactly sure what I'm even looking at. I want to build my own coils, but to start out, I want a to use 2 of the pre-made for a dual. I just want to check to make sure I'm not going to blow my face off. Thanks for reading, and if you have any additional questions, I will do my best to answer.
-spencer

 

[JD1]

If your battery is rated to handle 7 amps you should be fine. Your two 1.2 ohm coils in parallel should give you .6 ohms. Here's the calculator I use if you want to bookmark it. Watts - volts - amps - ohms conversion calculator

Be sure and check your build with an ohm meter. Those pre-built coils may not be to exact.

.6 is too warm for me. Unless you already know what you like, Id suggest a single coil build first, then add the other coil to see which you like better. I see a lot of posts that mention around .6 so that may work great for you. I tend to like the 1 to 1.2 ohm range for my single micro.

Good luck and let us know how it goes.

 

[spencerjames]

Alright, I'll do a single one first. Thanks for the reply mate.