Wire Wizard for Twisted Builds (DNA 200)

[sig-cmt]

Are you guys setting the coil type to parallel? How is it working out for you?

 

[yuseffuhler]

Are you guys setting the coil type to parallel? How is it working out for you?

You don't have to use the wire wizard section. Using the normal coil part works. Under the material/profile type, use the drop down tab for round/twisted. Then select how many wires and their pitch.

 

[sig-cmt]

Thanks. However, trying to download an accurate TCR curve for the dna 200 for twisted.

 

[yuseffuhler]

Thanks. However, trying to download an accurate TCR curve for the dna 200 for twisted.

In that case, parallel would be your best bet. Accuracy would probably not be spot on.... any idea what the twist pitch is? If its pretty loose i can see it being pretty close.