wismec RX200.... cant use TC

[haleysdadda]

Ok so I've had my RX for a week now running only in TC Ni mode. I'm running a dual 28g 9wrap 3mm ID .1 OHM build in a Mutation MT rta! My TC mode has been flawless ramping up to temp control in 1-2 seconds no matter the watts or temp! When it hits temp it still vapes perfectly! maybe slightly pulsing but that's what my IPV4s did! Correct me if I'm wrong but isn't that what TC is supposed to do?

 

[Douggro]

You might notice a little porpoising from the mod trying to maintain the temp but it shouldn't be drastic. Dropping the wattage down may help, at the expense of a slightly longer ramp-up time.

 

[DOMA]

Hate to say it but I believe the issue with TI is real and not a user issue. My RX200 is Hardware V1.00 with Firmware v1.08. Initially the device never displayed the new coil message when I attached a tank using TI mode. I have been reading the forums and someone posted about firing the mod with and without a tank attached. I fired the mod with the button the tank off the attached the mod and fired a few more times. Also switched between modes a few times then finally got the new coil message. Selected new coil and the unit worked like it should (Just like my IPV4). Unfortunately the story does not end here. If I leave the mod alone for a little while I have to repeat the process to get TI temp control to work again. Additionally I can not use the lock function because i will not get the new coil message if the resistance is locked. Sent a couple of emails to Wimsec service but no responses yet.