Wismec WM RBA

[vaper1960]

I have a Wismec WM rba for the Gnome King tank. It's a dual coil. I have searched and can't find any videos on how to build it. Anyone used one before or have suggestions?

 

[vaper1960]

This what it looks like (it has two allen grub screws and both coil leads share the same mounting holes):
Wismec™ WM RBA Coil Head for GNOME Atomizer

 

[Territoo]

I found this pic on the Wismec website. They also have a technical support section where you could email them.

support - Wismec Electronics Co.,Ltd

 

[UncLeJunkLe]

Not 100% certain but it looks like you just put the legs in the hole and tighten the grub screw. However if each coil shares the same set of holes for each leg, then it could be a bit of a frustrating job.

Get ready to waste some juice with a dual coil.

 

[vaper1960]

@Territoo , thank you. I saw that same image too. Thanks for the link.

 

[vaper1960]

However if each coil shares the same set of holes for each leg, then it could be a bit of a frustrating job.

I have an old UD Bellus that's like that... pain in the .... but I found a way to make something to held both coils while mounting. Gave up on the Bellus because it is such a tight space to work with and coils kept touching sides of chamber. Thinking 2.5 mm coils for this one.

 

[vaper1960]

What are the wicks in that image? Doesn't look like cotton... maybe silica?

 

[UncLeJunkLe]

That's a computer generated graphic aka fake.

 

[vaper1960]

That's a computer generated graphic aka fake.

Aha... I suspected that.