would these work

Status
Not open for further replies.

SteelJan

Super Member
ECF Veteran
Verified Member
Dec 14, 2010
385
1,130
Austin, Texas
www.youtube.com
Looks like it drops a lot of voltage across it, 2.75V loss. So, if you put two 3.7V batteries in series in it, so you'd have 7.4V, and you lose 2.75V right off the bat from the conversion, you will end up with 4.65V and go lower from there as the batteries deplete during use. Is that what you wanted to do?

And yes, dimensions? Does not say what size it is.
 

jhonutz

Unregistered Supplier
ECF Veteran
Apr 28, 2011
402
112
Romania Iasi
In your pictures i see that electronics PCB is into a plastic box. After you buy may remove that mini box and reduce dimension. :).

where did you see 2.75V lose?No way it`s impossible that circuit LM2596 have only 0.2 to 0.3V under load. I made a lot of regulators with that circuit, if it`s made correctly works very well
 
Last edited:

DaveP

PV Master & Musician
ECF Veteran
May 22, 2010
16,733
42,645
Central GA
The datasheet for the chip shows it to be a little under a half inch by a half inch. A heat sink is recommended for application. It looks to me that it can be set up to regulate with a fixed output voltage or as a variable output in various application setups. The spec below that says it can regulate from 4.75 less than input voltage to 40v.

VOUT Output Voltage = 4.75V <= VIN <= 40V, 0.2A <= ILOAD <= 3A

The way I read this to be makes it variable from 2.65v-7.4 with stacked 3.7v batteries. This would be a stacked battery mod that could go thermal on you. I certainly wouldn't try to put it into a tube mod that could build pressure and blow.

It can't produce more voltage than the input voltage, so it couldn't be used with a single Li-ion battery.

http://www.datasheetcatalog.org/datasheet/nationalsemiconductor/DS012583.PDF
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread