Wrong Resistance Readings

[Freddie BH]

Guys I dunno if this was asked before or not but here goes...

I got a new Kangertech topbox Nano and it's doing great, except that when I use either the 0.15 Ni200 or the 0.5 Clapton I get readings of 0.24 ohms on my mod, is that normal?

 

[Marc411]

Are you setting your resistance with a cold coil when using the Ni200?

And with premade coils the resistance can sometimes be a crapshoot. Have you tried more then one or pulled them off of the device and checked them on a meter?

 

[crxess]

Agreed with above.

Also note: Pre-made coil heads use pressure contact coil legs. they will change resistance slightly as they Seat to the housing and center pin. Not like locking a coil with set screws.