X9 Protank from Fast Tech issues

[Rob4092]

Just got my X9 Protanks from fast tech. When I put it on my Vamo 3, I get a "Low Load" warning and it won't ignite. If I back it up a few rotations, it works just fine but it is loose. Works fine on my SVD. Any fix for this???

Also, my X9 Protank 'whistles' when I vape off my Vamo 3. Any fix for this???

Thanks!

 

[HDVaper]

Get a genuine Protank would be my suggestion. For now though, try another head. Maybe the one that's in there is just squirrely.

 

[VikingQueen]

It is the head. There is a little wire sticking out at the base. Change the head or push the offending wire under the white grip of the head.

For the noise, I use a tank air controller. I use it for all my tanks that do not have ego threading. I do not mind an airy draw, but the noise drives me nuts!

 

[Zipp]

I had that issue with an evod once. The little rubber piece that separates the negative and positive leads from the coil inside the connector would somehow allow them to short together when it was compressed by screwing it down too tight. There must have been a bit of wire poking out that I couldn't see. Rebuilding the coil fixed it.

 

[HughDaHand]

eGo Chrome Cone for the 3.5 mL Dual Coil Tank

I use one of these under my 510 threaded stuff on my vamo, it helps with the looseness on some stuff that just doesn't get good airflow screwed all the way down. Also remove the head and run your finger around the rubber piece on the bottom of the head. Sometimes the wires stick out to far and when you tighten the device onto your mod they short out. If you can feel the wire trim it a little with some nail clippers.

 

[drsocal]

My experience has been pretty 50/50 with the x9 protank

 

[Rob4092]

You guys were all dead-on! It was the coil! Replaced it and everything is great. THANKS!!!!~

 

[Rob4092]

New issues from my new X9 ProTanks from FT. They both leak when I hit on them. I get juice in my mouth and lots of gurgling. Replaced the coils with "replacement heads" from FT and no help. Am I doing something wrong with these? Is there some way to fix them???

 

[Rob4092]

I just put genuine Kanger Pro Tank heads in my X9 Pro Tank and all is not good! No leaking...works great!