XL atty

[Knifemaker]

I've been playing wth the XL atty from the eGo along with it's cart. It hold a "LOT fo e-juice.

I ordered a V-3 on the 8th, and I just recieved a shippment on it the 13th.??? (A little too long for me. I'm very impatient!)

I know it won't fit, Buttttt---

I want to chuck the XL atty up in the lathe and turn off some of the OD down to the 510 attachment.
I'll know for sure in a few days. But I have a good feeling this will work, and without looking out of place!

Hummm--- A stainless eGo atty on a stainless V-3=WooHoo!!!

So when are they going to make a XL-LR atty?
Mike

 

[MXBNW]

Is this what your playing with?

Monster atomizer for eGo

 

[Knifemaker]

Yep,That's the one!

 

[BrockJ]

You can use an adapter to make up the space. 901 - 510 or something..
Seen it done. Seems to work fine

 

[MXBNW]

I will have to give them a shot. where did you pick them up at.

Yep,That's the one!

 

[MXBNW]

So are the ones at AV 901 or 510

You can use an adapter to make up the space. 901 - 510 or something..
Seen it done. Seems to work fine

 

[BrockJ]

I believe they're all 510 connectors so, if you had a 510 you'd have to do a 510 - 901 and then a 901 - 510 to add some length for it to fit up inside the cupped area..

 

[MXBNW]

Cool I will give them a shot. thlought it would be good for dripping.

I believe they're all 510 connectors so, if you had a 510 you'd have to do a 510 - 901 and then a 901 - 510 to add some length for it to fit up inside the cupped area..

 

[vapn]

I stuck one on my V3 last night. I have a 901 adapter on mine so it was a 901-510. It actually worked pretty darn good at 6v even.

 

[MXBNW]

Is every one geting these at the same place.

I stuck one on my V3 last night. I have a 901 adapter on mine so it was a 901-510. It actually worked pretty darn good at 6v even.

 

[vapn]

Is every one geting these at the same place.

I got my XL atty at TECC when they had their 50% off sale over in the UK. The adapter I can't remember where I got that.

 

[Knifemaker]

Well I cut the XL down shorter on the lathe and gave it a try. ( First time on 6-v for me.) It worked fine for a while until I held the button a little too long> HeeHee! POP!!!