ZattyG no resistance wire used wick build .8 ohm and 4.2v

[LongHaul]

ok so with Bishopheals idea used as a basis here all the credit goes to him for trying it first. think i have hit a home run with it....

silver NR wire 28ga
500# mesh
Zen ZAG
GGTS
4.2V freshly charged


double twisted the wire and wrapped the coil the same as Bish did in the video for the Ody, add juiced and kicked out awesome vapor at 1 ohm moved the NR wire up about 1/8 inch and dropped the ohm to .8 at first i got a slight shorting flavor but after moving the NR wire it went away.

and flavor........ahhhhh its mesh what more needs to be said.

pictures to follow in next post

 

[Bishopheals]

see if insulator doesnt melt like it did for me.

 

[Bishopheals]

I was going to do a special thing to add more mesh on outside because the wire sliced the mesh after 30 minutes of playing.

 

[LongHaul]

crappy pic will get better ones later

 

[LongHaul]

dont use insulators its the first thing i do to a zen

see if insulator doesnt melt like it did for me.

 

[LongHaul]

I was going to do a special thing to add more mesh on outside because the wire sliced the mesh after 30 minutes of playing.

been dripping it for a hour or so no problems yet.....will keep you updated

 

[LongHaul]

I cant quite wrap my head around how this happend, if you do the same setup without the tail then the same thing should happen in the ody. after all its the same setup only this is vertical and has a tail

I was going to do a special thing to add more mesh on outside because the wire sliced the mesh after 30 minutes of playing.

did you use a standard Zen wick. if so they are only about 3/8" of mesh rolled up they aren't worth anything to me.

 

[LongHaul]

it seemed like it wasnt getting the power that i knew it should be getting so i got the bright idea to pull the spring out of the bottom cap and as soon as i fired it it cut the wick so im back to the drawing board. there is so much power going through where the positive wire is hooked to it it just cooks the wires into ash

 

[LongHaul]

so im going to try to find a heavier wire mesh that still can take the power transfer

 

[Bishopheals]

i'm going to try that with silver too since i used nickel.

 

[imeothanasis]

Just great Long!
You use this atomizer in dripping style? Didnt you put liquid to its tank?

 

[LongHaul]

My wife decided to knock it off a table and break the tank so i have to order a new one this weekend...

 

[imeothanasis]

ahahaha, why she did this Long?

Ah, never mind, women

 

[Bishopheals]

it seemed like it wasnt getting the power that i knew it should be getting so i got the bright idea to pull the spring out of the bottom cap and as soon as i fired it it cut the wick so im back to the drawing board. there is so much power going through where the positive wire is hooked to it it just cooks the wires into ash

Yeap like i shown in the pics it slices the mesh totally which is why i need a thicker mesh on the outer ring part. I got some ideas That i will be trying and testing out. As you can see this will require some time of testing before its ready for prime time. Though on a ody it works flawlessly. I have to admit that ody and pen are like universal it can do anything and I MEAN ANYTHING all is needed is imagination.