Zenith V2 help

[Charbanger]

Wassup folks, I'm having a bit of trouble with my first rda. I using an Authentic Zenith V2 mounted on a Provari. The problem I'm having is getting a dual coil build that's not to low (resistance wise) for the Provari. I'm using A1 28g Kanthal, and I have tried twisted and non twisted. I have tried several different numbers of wraps on several different combinations of needles, drill bits, etc; however, I still can't get a build to chuk the vapor. I keep the "LO" atty displayed when I check the resistance through my provari. What am I missing, or should I just sell the V2 and stick with my Kay fun plus.

 

[Sthur]

The provari has a 3.5amp limit, so you need to build a single coil for good vapor on it. I would recommend a 1.6ohm single coil. This ends up at 3.5amps at 5.6 volts. That should give you decent clouds.

For better clouds use the dripped on a mech or a Vw box mod that can handle the lower ohms and amp draw.

ProVari Variable Voltage Ecig: Best Variable Voltage E Cig Available!

 

[Charbanger]

Thanks for the info Sthur, I ordered a T8. Hopefully It will be here soon so I can enjoy this RDA.

 

[Warpigs]

Welcome to ECF! Enjoy your new stuff when you get it