ZMAX Rev2 - Box Mod Wiring Question

[porkchop_express]

Hey guys,

Reposting this here, since I could only post in the newbie forum.

I am thinking about trying to build a box mod with the ZMAX board and have a question on how to wire everything up. If you don't mind, can I get a sanity check on this wiring diagram? Apologies to the upstanding folks I robbed images from, and thank you all for the wealth of information on this site.

Here is the diagram. I tried to add it inline but the file is too large.
http://i.imgur.com/QFj9tVL.png

Thanks,
Porkchop

 

[breaktru]

Yup, that will work. Only suggestion I have is to run the battery wires directly to the Zmax board to avoid any loses and not to tap off of the USB charger.

ZMax in a Box

 

[porkchop_express]

Ok yeah, that does seem best. Thanks Breaktru.

 

[porkchop_express]

Last night I bit the bullet and ordered the various components. All sellers are US based except the enclosure. Realized after purchase they are in China. Total cost so far is $46.

Aluminum Box - $8.10 shipped

Zmax PCB - $19.50 shipped

Evolv Charger - $8.50 shipped

18650 Holders - Lot of 5 - $3.00 not shipped yet

510 Connection - $6.75 shipped

Zmax lens cover - Out of Stock, on waiting list.

But...this morning I caved and bought an MVP2 so who knows when I will get around to trying this.