RDA Microcoil question

[Jawden]

well, i have a trident thats drilled out with dual 1/8 in airholes, and its very airy, (which i like) and it helps with those really low ohm builds. (~0.2-0.3 ohm)

really, its all down to personal preference. i'd start small and work your way up until your satisfied...i know too many guys who went too big the first time and ended up trashing top caps.

so if youre not satisfied with 1/16 then give the 5/64 a try and work from there.

 

[Jawden]

i should add that i have no loss of flavor with the airholes drilled out that big, contrary to what some say. and throat hit still kicks my ... sometimes. hahaha. and thats with 6mg nic.

 

[Muero]

each coil is 1.4 ohms. running in paralell halves it. so csantiago1911 is correct.

 

[Sthur]

Here is my first nimbus dual build came out too .8 ohms or 2 x 1.6 ohm 30 guage coils. My second build is a .57 dual with 28 guage with 2 x 1.2 ohm coils.



Refer to ohms law cals for how many watts and amp your pulling.

Ohm's Law Calculator

 

[Ojen924]

Parallel circuits are different when u calculate the ohms. The math is way different. But remember this the total resistance is always going to be less than the smallest resistance in ur circuit. And yes you will be subohm at .7. 4.2 volts at .7 ohms will come out to 6 amps load on you battery which is less then half of what your battery is rated at. Your safe


Sent from my iPhone using Tapatalk