Hi all,
I finally set up my first rba, at least I think I did,
I have a few newb questions regarding RBAs (I have an Aga-T2) in general...
1) Am I to leave all holes for wick/negative post screws in? I have three screw and a negative post, I removed one screw and used it and the unthreaded hole for a U-Wick config. The other two screws are tightened down, so no hole into my tank from the deck.
2) My coil came out to 1.7 Ohms. I'm using an eVic, what volts/watts should I vape 50/50 juice?
3) Do I position the airhole that's on the side of the top cap closest to where the wick is exiting out of the deck?
4) I'm using 30 gauge kanthal and silica. I have about 7/8 wraps around the U-Wick, I noticed that the middle of the coil portion is much blacker than the outer windings, is this normal?
5) The top left and right "shoulders" of my U-Wick is a bit frayed, should I worry about loose dry wicks entering my mouth/lungs?
6) I don't notice any more or less vapor production than my glasso, Kanger Protank, are genesis RBA purely for taste? Or should I be expecting some plumes and more vapor production than my clearos/glassos?
7) I'm chain vapor, do I need to wait between puffs for the silica wick to catchup?
Here's a pic of my setup, any comment and help would be appreciated it...
I finally set up my first rba, at least I think I did,
I have a few newb questions regarding RBAs (I have an Aga-T2) in general...
1) Am I to leave all holes for wick/negative post screws in? I have three screw and a negative post, I removed one screw and used it and the unthreaded hole for a U-Wick config. The other two screws are tightened down, so no hole into my tank from the deck.
2) My coil came out to 1.7 Ohms. I'm using an eVic, what volts/watts should I vape 50/50 juice?
3) Do I position the airhole that's on the side of the top cap closest to where the wick is exiting out of the deck?
4) I'm using 30 gauge kanthal and silica. I have about 7/8 wraps around the U-Wick, I noticed that the middle of the coil portion is much blacker than the outer windings, is this normal?
5) The top left and right "shoulders" of my U-Wick is a bit frayed, should I worry about loose dry wicks entering my mouth/lungs?
6) I don't notice any more or less vapor production than my glasso, Kanger Protank, are genesis RBA purely for taste? Or should I be expecting some plumes and more vapor production than my clearos/glassos?
7) I'm chain vapor, do I need to wait between puffs for the silica wick to catchup?
Here's a pic of my setup, any comment and help would be appreciated it...