Kanger Subtank Mini Ohmns Fluctuate

[FreeTimeNow]

So this is a little weird. I build the coils at about .8 or .9 ohmns and after vaping some, using a Sig 100+ boxmod (or the 30 watt sig too) the ohmns reading seems to fluctuate as high as 1.6 then back lower. Anyone have a clue why this would be happening?

 

[Katmar]

Bump for an answer....hope you get one!!!

 

[MrOcelot]

1. Sometimes when refilling the rba deck comes loose. Always tighten it when you refill. 2. On the very bottom of the rda deck the place where the air holes are sometimes also comes un screwed. Tighten that. 3. The brass 510 pin can you guessed it come loose. If the other two pieces are tight puts the brass pin up til it stops.

Hope this helps

 

[jbeef86]

I have had this before when I had a bad coil built. It would make all my mods wonky. Readings would go off and the wattage would jump around on its own. Either coil was too many wraps or something was touching like the legs weren't cut down tight enough to the screw. There isn't a large gap at all from the screw to the chimney base.

 

[Ablonz]

+1 for MrOcelot above.