Hello All,
I dont know if this is the correct forum to post this, if its not then please move it to the correct one.
So, I have bought the latest HB DNA40 (with the atty lock feature) and I have some questions.
I have a sigelei box mod 150w using it with Magma at 1.2ohms. When I place my magma on my new HB DNA40 (Wattage Mode) sometimes it reads at 1.15 or 1.16 or 1.17 and when I push the fire button the ohms jump from 1.15-1.19. On my ohm meter it reads 1.26. Keep a note that I didnt have any ohms jump on my Sigelei its always 1.2. So I am sure that the screws are tighten plus the connection on the spring loaded pin is good.
Is this normal or I have a defective hb dna 40?
Also using temp control with a Subtank mini plus nickel coils(0.15ohms) the rest resistance reading some times its 0.13 or 0.14 or 0.15 or 0.16. Is this normal? I am changing places which might have temperature impact?
Also if my rest resistance is 0.14 and I vape it for 1-2 hours and then place it on the table and come back to vape it again after half hour the ohm may jump to 0.15 or 0.16 (I dont use the atty lock)
I hope I was clear and looking for you advises and information.
Thanks
I dont know if this is the correct forum to post this, if its not then please move it to the correct one.
So, I have bought the latest HB DNA40 (with the atty lock feature) and I have some questions.
I have a sigelei box mod 150w using it with Magma at 1.2ohms. When I place my magma on my new HB DNA40 (Wattage Mode) sometimes it reads at 1.15 or 1.16 or 1.17 and when I push the fire button the ohms jump from 1.15-1.19. On my ohm meter it reads 1.26. Keep a note that I didnt have any ohms jump on my Sigelei its always 1.2. So I am sure that the screws are tighten plus the connection on the spring loaded pin is good.
Is this normal or I have a defective hb dna 40?
Also using temp control with a Subtank mini plus nickel coils(0.15ohms) the rest resistance reading some times its 0.13 or 0.14 or 0.15 or 0.16. Is this normal? I am changing places which might have temperature impact?
Also if my rest resistance is 0.14 and I vape it for 1-2 hours and then place it on the table and come back to vape it again after half hour the ohm may jump to 0.15 or 0.16 (I dont use the atty lock)
I hope I was clear and looking for you advises and information.
Thanks
Last edited: