hey all.
got a mech mod incoming that uses a 20700 (though comes with a sleeve for an 18650).
bought a Keeppower 20700 3000mAh from one of the trusted vendor's on @Mooch 's battery chart (ecoluxshopdirect.co.uk).
here's the page for it.
Keeppower 20700 3000mAh IMR Battery EcoluxShopDirect.co.uk
and here's the blurb (i'm ignoring the use of the word Vattery)
Genuine Keeppower 20700 High End Vattery
Widely used for vaping , E-Cigs , Mech MOD's
We rate this battery 30A CDR / MVA
Ready for coils 0.13 Ohm's
Size : 20.45mm x 69.80mm
Nominal Voltage : 3.60V
Nominal Capacity : 3000mAh
Rated Capacity : 3000mAh
Charging Metod : CC/CV 4.20V
Discharge Voltage : 2.60V (Average Cut Off)
Operating Temperature : -20 ° to 60 °C
Standard Charging Current CC : 1500mA
Rapid Charging Current : 3000mA Max.
Continuous Discharge Current : 20A
Max. Short Pulse discharge : 35A
Weight : 58gr. max
Colour : Black , Silver
Protection Circuit Board / PCB : No / Unprotected
Version : Flat Top
Type : Rechargeable : High Drain , IMR / INR
conflicting CDR there. vendor says 30A and the detail states 20A. think 20A seems more plausible. any thoughts?
got a mech mod incoming that uses a 20700 (though comes with a sleeve for an 18650).
bought a Keeppower 20700 3000mAh from one of the trusted vendor's on @Mooch 's battery chart (ecoluxshopdirect.co.uk).
here's the page for it.
Keeppower 20700 3000mAh IMR Battery EcoluxShopDirect.co.uk
and here's the blurb (i'm ignoring the use of the word Vattery)
Genuine Keeppower 20700 High End Vattery
Widely used for vaping , E-Cigs , Mech MOD's
We rate this battery 30A CDR / MVA
Ready for coils 0.13 Ohm's
Size : 20.45mm x 69.80mm
Nominal Voltage : 3.60V
Nominal Capacity : 3000mAh
Rated Capacity : 3000mAh
Charging Metod : CC/CV 4.20V
Discharge Voltage : 2.60V (Average Cut Off)
Operating Temperature : -20 ° to 60 °C
Standard Charging Current CC : 1500mA
Rapid Charging Current : 3000mA Max.
Continuous Discharge Current : 20A
Max. Short Pulse discharge : 35A
Weight : 58gr. max
Colour : Black , Silver
Protection Circuit Board / PCB : No / Unprotected
Version : Flat Top
Type : Rechargeable : High Drain , IMR / INR
conflicting CDR there. vendor says 30A and the detail states 20A. think 20A seems more plausible. any thoughts?
Last edited: