Mini Protank 1.5 ohm?

Discussion in 'Clearomizers' started by drugan, Jan 3, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. drugan

    drugan Full Member

    Joined:
    Oct 18, 2011
    Location:
    usa
    I use a mini protank with a 3.3 volt with an 1.8 ohm for times when I need something small. Has anyone tryed the 1.5 ohm with a 3.3 volt? I was thinking of ordering a few.
     
  2. jdanderson1449

    jdanderson1449 Senior Member ECF Veteran

    Joined:
    Dec 7, 2013
    Location:
    Lincoln, Nebraska, United States
    Most of my protank 2 builds are1.5-1.3 ohms. I use them on an eGo twist in any range from 3.2-3.8 volts without any problems. Just keep in mind that running at a higher power setting, i.e. above about 8 watts will shorten the life of your coils.


    Sent from my iPhone using Tapatalk
     
  3. drugan

    drugan Full Member

    Joined:
    Oct 18, 2011
    Location:
    usa
    Thanks for the reply. I have been useing 2.4-2.8 ohm with a VV/VW aroung the house but when I am out I like to carry something small. Would you expect to see much of a difference between the 1.8 and 1.5 ohm with a non-VV ego?
     
  4. jdanderson1449

    jdanderson1449 Senior Member ECF Veteran

    Joined:
    Dec 7, 2013
    Location:
    Lincoln, Nebraska, United States
    Most fixed voltage eGos are putting out somewhere between 3.4-3.7 volts so you should be fine as long as you're not a hopeless chain vaper. It'll get a little warm and you might notice a little burnt flavor. If that happens I usually just let it cool down a little before I hit it again.


    Sent from my iPhone using Tapatalk
     
  5. Caridwen

    Caridwen ECF Moderator Senior Moderator Verified Member ECF Veteran

    Supporting member
    Joined:
    Jan 15, 2011
    I'll move this to clearomizers for more input. :)
     
Thread Status:
Not open for further replies.

Share This Page