My build is jumping resistances...

[IronLuke55]

I made my second helix coil (0.3mm diameter, 6 wraps, 28g around 24g kanthol) and it was reading out at first with a 0.26ohm with a single coil. After I wicked it, juiced it and everything, it jumped to a 0.8 and then down to a pretty regular 0.4 and now, after just re-dripping is reading 0.59. What's going on here!? I have it on a pegasus 70Watt mod if that helps any.

 

[ImThatGuy]

Take out your wicks. Retighten your screws. Pulse your coils to oxidize. Then try again.

 

[IronLuke55]

Take out your wicks. Retighten your screws. Pulse your coils to oxidize. Then try again.

Did it.... Really wicked and all and it's still jumpy. I threw my crown tank on the same mod and it also started "mildly" jumping around around from 0.48-0.61 ohms on a 0.5 coil (from a box of coils that I bought for the Crown)

 

[IronLuke55]

Did it.... Really wicked and all and it's still jumpy. I threw my crown tank on the same mod and it also started "mildly" jumping around around from 0.48-0.61 ohms on a 0.5 coil (from a box of coils that I bought for the Crown)

I'm starting to think it's my mod....

 

[ImThatGuy]

Check that floating 510 pin. See if it's damaged.

 

[IronLuke55]

Wait... Found it.... Loose post screw on a negative side, had a hidden hot spot that was throwing everything off

 

[ImThatGuy]

Wait... Found it.... Loose post screw on a negative side, had a hidden hot spot that was throwing everything off

Glad you found it. Now go vape.

 

[IronLuke55]

Glad you found it. Now go vape.

Yup, I think the coil on my crown tank is getting gunky anyways which could potentially throw of the resistance also, so I'm going to be switching that out soon also lol