Search results

I got the idea from a person I follow on IG, she does them and I was looking at the wiring and didn’t see a mosfet, I can always double check it but I’m pretty sure there wasn’t one

If done properly and proper precautions are used i will be fine. I just need some help to decide what gauge wire would work best.

Read a little bit online, it’s a 40A pulse discharge and 15A Continous so I’m right but I’m also wrong

Imren 18650 3200mAh 40A IMR Vape Battery - 18650 Battery Store These are the batteries I have, I have 20 A 18650s as well, which might be what I ise

Okay, what I wired 2 18650s that are both 20A, would 14 be the optimal choice? I’m not planning on a mosfet or anything, just batteries to button to 510. Or should I go 12G to be safe?

It says 40A on my batteries

Im building a series box mod, and i will be using two 18650 40 A batteries, what gauge wire should i use? i was thinking 10 gauge, would it make a difference if i wanted to throw in some 20 A batteries (would the 10 gauge not work or something odd). im trying to figure out the best gauge wire

no hard feelings bro, i dont even put batteries near the mod. at least until i can swap out the mosfet for a good one. hoping that should fix my issue and i can use the mod :D

ive read up on it and know more now, yall can relax now, im not going to blow myself up. plus i only ran the .05 coils for one pull and decided that i shouldnt probably run that low. I got the coils to about .12 ohms now, and just have to replace my mosfet

thank you, i may look into replacing it. Ive been waiting for a response like this instead of "read up on battery safety" like yes i know, .05 ohms is low, but i have a parallel mod, which runs quite a bit lower than series mods

okay, i did look at the Tugboat V2, Thoughts on that?

If i do happen to get a mech mod, what would you reccomend? id prefer it to be around $100

I swapped out the .05 coil to a .2 Tiger pre built, but did that about an hour ago. Something internal is going on

Think i found the culprit, again lol. The wire to one end of the battery sled isnt connected XD missed that the first go around

Scratch the painters tape, ill use duck tape. trying to keep from getting adhessive all over the inside of the mod

i tested it out on my Sigeli Moonbox, and it works just fine, im gonna try and cover the inside with some painters tape or something and see if that solves it, but not going to leave it there. If it does fix it, i will probably go buy some electrical tape tomorrow

i feel like an idiot, there was a small piece of 26 g SS in the juice well, i think that was the problem *facepalm*... never mind i lied, still having the problem

nevermind, still having the problem, tried keeping the RDA unscrewed where it made the connection but didnt touch the case

Im using brand new IMREN 18650, and i thing i figured out what might be grounding it. Some paint has come off the top where other RDAs and such have been, and might be from the RDA touching the bare metal, i was searching google and found that was a problem with one persons

took it apart and made sure what i thought was grounding wasnt, still wants to auto fire D: