That was an odd choice of the first finger to go!deserves a facepalm
◙ Li’l PINCH (←thang) ◙ pdib (←maker) ◙ not sayin’ (←just sayin’) ◙ shuh-ZAM! (←hyperbole)
- Thread starter pdib
- Start date
- th_trl_thread_readers 0
- Status
Ha!
Ha! When family members see me holding any sort of tool, they run from the room in terror, like I'm the Texas chainsaw dude.
Considering its the wrong hand, I'd have to agree.
Otherwise we might be at odds on that one.
[emoji23] Priorities...
Tapatyped
Yes you would, they have warning stickers like this on all the machines
Hazardous work environment....
Nah!
Think INSIDE the box on this one, Tamer.
Tapatyped
LMAO!
Sent from my iPhone using Tapatalk
Yes you would, they have warning stickers like this on all the machines
Hazardous work environment....
I knew it!! [emoji27] I've had enough accidents as it is with the hammer
Sent from my iPhone using Tapatalk
I just sent off a piece of wood to be made into a drip tip. After August 8 that would be a "new" product and illegal to sell. Same goes for any newly designed DTs even if it's just a new color or other design variation with no possible effect on performance or safety.
I've read the truly excellent motion for summary judgment in the Nicopure suit, and a drip tip maker should intervene. A ten page motion incorporating Nicopure's and simply pointing out the absurdity of requiring a PMTPA for a drip tip would be very compelling and impossible for the FDA to effectively rebut,
Yes you would, they have warning stickers like this on all the machines
Hazardous work environment....
Someone pointed out to me that government mandated safety stickers are racist.
It's always the white stick figure doing it right and the black stick figure doing it wrong.
Someone pointed out to me that government mandated safety stickers are racist.
It's always the white stick figure doing it right and the black stick figure doing it wrong.
People can overdo it sometimes [emoji848]..to the extent of being ridiculous.
Sent from my iPhone using Tapatalk
Nah!
Think INSIDE the box on this one, Tamer.
Tapatyped
That's a rather big box!! [emoji54]
Sent from my iPad using Tapatalk
Ok my friends, last few pics, machining the slots.....
DONE
Good Luck everyone, I hope you enjoy using them as much as I did making them
DONE
Good Luck everyone, I hope you enjoy using them as much as I did making them
It's a shame that not everybody isn't going to get one of these. Thank You to Marcus and Steve! However Peter does the picking a few people are going to be very happy.
Wanted to share some pics of the Clear Caps being machined. For my one off custom stuff, I dont CNC machine them, I machine them manually to add a bit of me to it, so each piece is unique and truly custom
This is the machine that the clears were run on
First steps, facing the end and rough milling the bore:
Then I size the bore with a boring bar:
Now drilling the drip tip hole:
Now I turn the Outside to size:
Now I cut off the part to flip it over:
That leaves this:
I face the Part to length:
Then turn the drip tip to size:
Finally, part is done except for the slots and polishing up nice and clear
Off to the milling machine to do the slots.........
Very cool.....I have always enjoyed seeing the process of how something is made! Thanks so much for sharing
And thanks again for doing these
- Status
Similar threads
