1.3 ohm Cisco on a 900 mAh eGo battery?

[killovicz]

Evening ladies and gents

I have a Cisco atty at 1.3 ohm it was 1.4 ohm for many month but it dropped down to 1.3 and stayed there for couple of month.

I've been using it for some special brew on a unprotected mod, powered by fully loaded IMR's.

I've just cleaned it, tapped it with some tobacco juice and run it on my vari at 3.4v (same as eGo). Great amount of vapour, fantastic flavour and its vaporizing nic for sure!

--------------------------------------------------------------------

So I was wondering if it would be safe to try screwing it on a eGo 900mAh battery and give it a puff?

-->>if answer is perhaps, what is the worst thing that could happen:

1. eGo's electronics fry and the battery stop working.

2. eGo blows up. <<--worst case scenario

3. eGo kills Cisco, somehow (and perhaps blows up at the same time) <<-- doomsday scenario

Thanks in advance, Killovicz

 

[Switched]

Chances are you may fry the mosfet on the eGo. Yes folks vape them on eGos ect... 1.5Ohms, at 1.3 you are pulling waaaay too much current. LR atties were designed to be vaped on high drain batteries of 450mAh or better (these were originally 1.612Ohm) folks ran with the 450mAh and left the High drain behind

 

[killovicz]

Thank you very much for your reply, your time and effort is much appreciated .

I wouldn't mind bowing eGo (I had proVari for year and a half), but I'm very much afraid of doomsday scenario :/

Could eGo battery somehow kill Cisco, any1? <<--while blowing up it's self, perhaps? I had this 1 since 06/10/2011 but it feels MUCH LONGER, I use it almost on daily basis..