Just like the title says. I am running a 2.9ohm Kanger T3S at 4.5V.
When firing my Vision Spinner, it will sometimes "pulse" on and off (rarely). The light goes off too. It'll come back on and fire the atty again in less than a second.
I am thinking the button itself is just wearing out, cause sometimes it doesn't fire at all unless I wiggle my thumb around it while holding it down.
My spinner is only 1.5months old.
Thoughts anyone?
When firing my Vision Spinner, it will sometimes "pulse" on and off (rarely). The light goes off too. It'll come back on and fire the atty again in less than a second.
I am thinking the button itself is just wearing out, cause sometimes it doesn't fire at all unless I wiggle my thumb around it while holding it down.
My spinner is only 1.5months old.
Thoughts anyone?
Last edited: