2011 GGTS Atomizer Compatibility

[Wylie]

My new (and awesome!) 2011 GGTS is awaiting its new AVS v3 on pre-order from COV and I had a question about atomizer compatibility if I'm not using AVS/UFS. The new GGTS fits a 510 but how do I get an 808 or 901 to fit on there?

I'm sure it's something simple, but I can't figure it out. My 2010 GGTS has been used exclusively with AVS 2.0, so I guess the question applies to any GGTS.

 

[Wylie]

Ok... I read a post just a bit further down and it appears there is a re-threader of some sort. I'll look on the COV site for that. I just assumed the compatibility was 'native' on the GGTS.

Thanks.

 

[zuTma]

the rethreader should came with your GGTS infact you should have 2 of them.

 

[Wylie]

the rethreader should came with your GGTS infact you should have 2 of them.

Um... duh! There, at the bottom of the little velvet bag are... two re-threaders. Thanks!

 

[B-Rad_The_Mad_Vapr]

The rethreader is for the 901, the 510 and 801 are both native

 

[Wylie]

That's helpful. I use three atomizers: KR808D, 901, and 510. The first two use the re-threader-- I guess they have the same threads. And I guess the 510 and 801 do, too?

 

[B-Rad_The_Mad_Vapr]

No, the 510 is a male thread and screws inside like the rethreader, the 801 is a large female thread ( larger than 901/808) and screws directly over the entire native connector.

 

[Wylie]

Dang, this thing is flexible!