28 gauge 5/6 wrap is terrible on an evic.

[Bullypop]

Does anyone know why I can't vape a 28 gauge 1.3 ohm coil on an evic. I'm not getting vapor production.

 

[Haber]

I had the same issue with the evic you need a higher gauge to reach higher ohms. The evic has a 2.5 amp limit so at 1.3 ohms it will only fire at 3.2 volts....even if it says it is at 4.5v or higher it isn't firing at that voltage. I was pulling my hair out with the exact same issue

 

[crxess]

I had the same issue with the evic you need a higher gauge to reach higher ohms. The evic has a 2.5 amp limit so at 1.3 ohms it will only fire at 3.2 volts....even if it says it is at 4.5v or higher it isn't firing at that voltage. I was pulling my hair out with the exact same issue

11 Watts -that is 3.7v not 3.2v Also easier to run that way with an AW IMR battery. 2.75 amps achieved on eVic.

You might consider getting a Mechanical Mod for running Low ohm coil tanks. Even the Vamo kind of fights to get the job done.

What tank are you trying to run? I have found the RSST to be more responsive than my AGA-T's

 

[Haber]

It has the ability to hit 11w with higher ohm attys at higher volts. With LR attys you can set it to 11w but it will only fire at the wattage that does not exceed the amp limit which is 2.5.

 

[Bullypop]

I'm running an aga t2. I have some mechanicals there just some clones and sigeleis. I haven't even taken them out the box.

 

[gjshaw29]

Try it on the mechanicals you'll love it

 

[Bullypop]

I'm gonna. Gotta go get some good batts. It seems better today with the evic on a full charge. I didn't thin that would make a difference on a device with a pcb. Either way I need to get these mechs going.