3.7 Mod Box Voltage Drop

[[amp]]

I recently got one of the pre-made Battery Voltage Indicators from madvapes and was doing some testing of my gear. I noticed my 3.7 box mod would drop from 4.2v to 3.5v when under load (LR510 atty). So I tried one of my Riva batteries and noticed there was almost no voltage drop with the same atomizer. I assume this is from the regulator in the Riva, so Im wondering is there something I can add to my box mod that would do the same thing?

 

[jhonutz]

first what kind of regulator you use on your boxe.I think is a boost convertor with 1 battery, with what IC you made that boxe?
Because of IC or a wrong connection, your booster don`t work . A good chose is PTN04050C from Texas Instrument

 

[[amp]]

Right now its basic battery/switch/connector

 

[jhonutz]

uff I understand.. you have a pour battery and don`t offer enough current, try to use AW 18650 IMR the best, or 18650 2400mah from China.

 

[[amp]]

So, then this type of drop is pretty typical then with the 14500 batteries?

 

[jhonutz]

yep i think so. An 1.5 ohm atty drain from source around 1.4A - 1.5 A, a 14500 have around 900 mah, because of that V out drop down

 

[GAC]

yep i think so. An 1.5 ohm atty drain from source around 1.4A - 1.5 A, a 14500 have around 900 mah, because of that V out drop down

Actually, a 1.5 ohm atty draws 2.5 amps at 3.7v. Get yourself a AW IMR 14500 and you will get better performance, those can handle a higher drain rate.

 

[[amp]]

I'll give one of those a try.