I got a new eGo and blew both atty's in one night, I thought they were both pretty wet, I am dripping. What the heck am I doing wrong here.
510 atty
- Thread starter cubfanthad
- Start date
- th_trl_thread_readers 0
- Status
How many drags are you taking in between dripping? Sounds to me like you are going to long without adding some more ejuice. Think of it like this. About 6 or seven good pulls off of it, then add more. The filament will get red hot when to dry. You can look in there and see it on a 901, not to sure about a 510 though. When you are starting out with a new atty, the amount of drops should be increased by two or three imo. Are you out off atty's now? If not give this a shot and see if it helps. Good luck!
I'm out, ordered some more on friday before my eGo even arrived, but LF is behind so I'm frustrated and back on analogs. I put 4 drips in but apparently that wasn't enough, ugh. When I get the new ones I'll try your advice, Thanks.
There is a learning curve on these things man. Don't get down on yourself. Smoking a few more analogs won't hurt anything. Let us know how it goes.
Don't give up. Always keep them wet. Let them cool inbetween vapes. If they get too hot, they'll die on you. LR atty's burn hotter than the standards so keep this in mind. LR's will eat more juice faster due to the heat they put off. Take shorter draws on them until you figure out to what extreme you can push them too. Good luck and keep us posted.
exactly! hang in there!
and the LR atties are juice guzzlers!
if you need anything, shoot me an email!
Abe you took good care of me this morning, thanks again,
btw they were reg 510's not LR although I ordered some LR 510's from LF along with a 5 pack of reg 510's. My prob is that they keep leaking so I have been thinking I'm dripping too much. Then I blow them out and clearly don't wet them down enough or something, I'm putting like 4 or 5 drops in after I blow them out. Guess I'll try 5 or 6 drops.
btw they were reg 510's not LR although I ordered some LR 510's from LF along with a 5 pack of reg 510's. My prob is that they keep leaking so I have been thinking I'm dripping too much. Then I blow them out and clearly don't wet them down enough or something, I'm putting like 4 or 5 drops in after I blow them out. Guess I'll try 5 or 6 drops.
they can be finicky at times. but when you get one on a roll, it's an enjoyable ride 
or cartomizers ???
or cartomizers ???
Last edited:
My recommendation is, starting with a clean atty, 3 drops directly on the atomizer. Vape. Add one drop every few vapes, every now and then 2 drops.You'll get a feel for how much is too much, and you can taste when it is too little. Gurgling, leaking=too much, not enough flavor=too little.
- Status
