Hey im new to this forum and its awesome to finally get some answers to all of my questions in terms of vaping, but since i can't post in technical problems for a few posts i figured id try to get some answers here...
I had bought a hana modz clone not too long ago, and its never caused me any issues until just recently; the 510 center pin has gotten pressed down to the point where rda wont even make a connection, but even worse is that the insulator around it has gotten pressed out to the sides and looks as though its about to fall out.
I can still use my atlantis without issue, but i was wondering if it was possible to replace that insulation, and if so how would i do it? I searched the forum and online and i couldnt find any answers... Thanks!
I had bought a hana modz clone not too long ago, and its never caused me any issues until just recently; the 510 center pin has gotten pressed down to the point where rda wont even make a connection, but even worse is that the insulator around it has gotten pressed out to the sides and looks as though its about to fall out.
I can still use my atlantis without issue, but i was wondering if it was possible to replace that insulation, and if so how would i do it? I searched the forum and online and i couldnt find any answers... Thanks!
