So this has been bugging me for a while.
I have a silver bullet and I bought a 510 to 510 adapter so I can use a drip shield so I dont get extra juice all over.
The last two atomizers i used (and all in fact) doesnt quite fit as it is too tight on the 510 adapter. The Adapter fits sung on the battery. For the atomizer however this causes the center pin on the bottom of the atomizer to get pressed inside. Using a LR atomizer it seems to melt or push (due to the non fitting adapter) in the atomizer pin to the point where even if I pop it out it gets pushed in very easily causing one to literally become useless and short out every time I tried to fire it.
I put on a new atomizer and only twisted it on until it felt slightly sung (about 20% of threads showing) which shows the two air holes. This causes ALOT of air to go though (like sucking through a straw) and makes a loud gurgle on the first hit. Before it was a tighter draw like sucking though a coffee straw and it made a more muffled gurgle.
Is this normal?
I have a silver bullet and I bought a 510 to 510 adapter so I can use a drip shield so I dont get extra juice all over.
The last two atomizers i used (and all in fact) doesnt quite fit as it is too tight on the 510 adapter. The Adapter fits sung on the battery. For the atomizer however this causes the center pin on the bottom of the atomizer to get pressed inside. Using a LR atomizer it seems to melt or push (due to the non fitting adapter) in the atomizer pin to the point where even if I pop it out it gets pushed in very easily causing one to literally become useless and short out every time I tried to fire it.
I put on a new atomizer and only twisted it on until it felt slightly sung (about 20% of threads showing) which shows the two air holes. This causes ALOT of air to go though (like sucking through a straw) and makes a loud gurgle on the first hit. Before it was a tighter draw like sucking though a coffee straw and it made a more muffled gurgle.
Is this normal?
Last edited:
