5v Eclipse Tin

[cyberwolf]

Well, I finally got around to finishing a project that has been laying around for a few weeks. These tins are just the right length for stacked 16340s, so I gave it a try. I used a squared off piece of PVC to mount the switches and protect the components. The circuit board with a 5v regulator gets covered with electrical tape after the photo.

Thanks to Connman for the Eclipse tin idea and, though I didn't realize it until just now, the 5v regulator diagram on madvapes site as well.

 

[Connman]

Real nice looking eclipse mints tin mod cyberwolf.
Like the way you used that PVC pipe and have a off/on switch for the main power.. That is a must have with the 4 or 5 pin regulators.
One sweet clean mod. I was thinking of using the 2 16340s in one myself a while back till I got flooded with all these other mod ideas. Think now they are going into a Jumbo Push Pop for that 5 volt satisfaction. Or maybe a eclipse mints tin as you have done there. Or maybe one I haven`t come up with yet.

I also need to toss a Thanks out there to EzDuzit for that is where I came up with my diagram in his postings Here Just made it easier for me to undersatnd..

 

[5cardstud]

Good looking eclipse mints mod.

 

[rekeybobby]

now thats creative now you have to get a e juice that taste like that and you can tell people that dont know about ecig that your vaping gum and make a killing

 

[bsmoss]

lmfao... that is verry sweet!

 

[IcyShadowz]

is there a how to on this one like a step by step thats really sweet

 

[Elendil]

Modders really are the coolest people.

 

[IcyShadowz]

Modders really are the coolest people.

I agree with you!!! within the last hour of looking on here i think like 90% of the stuff i got laying around is getting scared and ready to move out on me lol
also found the how to on this one http://www.e-cigarette-forum.com/forum/battery-mods/98627-18650-eclips-mints-tin-how-mod.html its not exactly the same but gives you a general idea