I have a 601 e pipe and one of my special lithium batteries is not working. The charger shows it is fully charged, but when I put the contact in place it will not work. The other battery works just fine. Both batteries worked fine when I purchased the product, but this battery just started doing this. Any suggestions? Also does anyone know how to replace the atty when it is needed?
601E Pipe
- Thread starter gsargent51
- Start date
- th_trl_thread_readers 0
- Status
I'm not familiar with the model. Are these batteries sealed? Or like a slim ecig auto battery with an open hole the threaded end? Autos or any battery with an open hole in the end can be damaged or killed by juice leaks.
You should always have spares of everything. Atomizer - are you cleaning it? And make sure you have at least one spare. If you are keeping it clean and it still gets degraded (lack of warmth, vapor, flavor) or dies, then you need a new one.
You should always have spares of everything. Atomizer - are you cleaning it? And make sure you have at least one spare. If you are keeping it clean and it still gets degraded (lack of warmth, vapor, flavor) or dies, then you need a new one.
From what i have read the pipe body itself is the atomizer so i think it's a case of buying a whole replacement bowl once it's dead . As for the battery it may be dead or not making contact as i believe the cap on top is a little fiddley to close - however please stop trying to put it on charge - if the light says it's done putting it back on charge for an extended charge may trickle more power into it which if it is full won't do the battery any good - i would recommend getting a cheap multimeter and seeing if the battery is letting out the correct voltage . Hope that helps a little
- Status
Similar threads
