70PG/30VG mix?

[jak510]

I usually vape 100%PG juice and I recently tried a 70PG/30VG mix from VapeDudes in a carto and really liked the thicker vapor. I really didn't notice a terrible drop in throat either at 24mg. I have some DCT's with the dual prepunched holes in it from AltSmoke. I'm going to place another VapeDudes order and I don't want to get this mix if it's going to give me wicking problems. What do you guys think? Thanks

 

[Unforeseen]

Wicking problems mostly occur with 60PG/40VG and higher (VG%). Although, some have reported good results with as much as 100% VG. It's still well known that high VG kills cartos and gunks up the coil on atomizers.

You'll be fine with 70/30 since it's still fairly thin.

 

[PittBoss]

I personally don't run into wicking problems with commercial liquids, until I hit about 40/60, but mostly higher. At 70/30 there should be no problems for you!

 

[jak510]

Great! Thanks!

 

[Provangelist]

I love 100% VG juices. They hold up well in my tank, even with the tiny punches in the cartos, and I can still get a carto to last a couple of weeks. I normally use Johnson Creek VG juices. Maybe it's something about their juices that make them work so well.

 

[Vapoor eyes er]

I vape 60/ 40 PG/ VG in my tank without problem. If I were to raise the VG I'd consider making a larger hole in the carto but I find 60/ 40 wicks very well.

 

[ka724ka]

I usually go with 75 PG/25 VG as suggested by the vendor.

 

[wseyller]

Depends on size of holes but my smoketech two holes works ok with two at 70 pg. If it floods too much you can cover one of the holes. I break a toothpick off in the hole.

Sent from my DROID BIONIC using Tapatalk 2